Club Car Carryall 300 2021, Maintenance And Service Manual

Page: 311 / 596

GASOLINE VEHICLE - TROUBLESHOOTING
AND ELECTRICAL SYSTEM Test Procedures
18
TEST PROCEDURE 3 – Ground Cables
See General Warnings on page 1-1.
NOTE: This is a continuity test for the main ground wire of the vehicle. An additional ground wire is located on top
of the fuel tank.
1. If necessary, see Testing Basics.
2. Disconnect battery and spark plug wire.
3. Check the following wires and cables for clean, tight connections and continuity (Figure 18-3, Page 18-13) :
– Check the starter/generator ground cable (black wire) from A1 terminal to chassis.
– Check the battery ground cable from the disconnected terminal to chassis.
– Check the engine ground cable from engine block to chassis.
4. The reading should be continuity. If the reading is incorrect, clean and tighten cable connections. If the
connections are good and the reading is incorrect, repair or replace the wire or cable.
1. Battery Ground 2. Main Wire Harness Ground 3. Engine Ground Cable 4. Starter/Generator Ground (from A1 Terminal) 5. Voltage Regulator
Ground Wire (from electrical component box)
Side-Post Battery Shown
Figure 18-3 Ground Wires and Cables
2021 Carryall 300 Maintenance and Service Manual Page 18-13