Club Car Carryall 300 2021, Maintenance And Service Manual

Page: 207 / 596

ELECTRIC VEHICLE - ELECTRICAL
COMPONENTS Run/Tow Switch
13
WARNING
• Make sure that the vehicle operates in the forward direction when the Forward/Neutral/Reverse control
(FNR) is in the F position.
• Make sure that the vehicle operates in the reverse direction when the Forward/Neutral/Reverse
control (FNR) is in the REVERSE position. The reverse buzzer will sound as a warning when the
Forward/Neutral/Reverse control (FNR) is in REVERSE.
• Make sure that the vehicle does not operate when the Forward/Reverse switch is in the NEUTRAL
position.
RUN/TOW SWITCH
See General Warnings on page 1-1.
TESTING THE RUN/TOW SWITCH
See Test Procedure 3 – Run/Tow Switch on page 12-15.
RUN/TOW SWITCH REMOVAL
1. Disconnect the batteries and discharge the controller. See Disconnect the Batteries – Electric Vehicles,
Section 1, Page 1-5.
2. Using a 5/8 in (16 mm) socket, remove Run/Tow switch boot/hex nut (6).
3. Remove Run/Tow switch (10) and nut (9) from bracket (5).
4. Disconnect the two-pin connector (7) and remove switch.
RUN/TOW SWITCH INSTALLATION
1. Make sure groove on switch is aligned with tang on bracket. Tighten Run/Tow switch boot/hex nut (6) to
16 in·lb (1.8 N·m).
2. Connect the batteries. See Connect the Batteries – Electric Vehicles, Section 1, Page 1-5.
W O
T
N
U R
10
9
5
6
7
2991
Figure 13-2 Run/Tow Switch
2021 Carryall 300 Maintenance and Service Manual Page 13-3