Club Car Carryall 300 2021, Maintenance And Service Manual

Page: 293 / 596

ELECTRIC VEHICLE - TRANSAXLE Transaxle
17
CAUTION
1
2
3
4
1. Motor Mounting Bolts
2. Input Pinion Gear
3. Intermediate Gear Assembly
4. Differential Gear Case
2639
Figure 17-10 Detach Axle From Leaf Springs
Figure 17-11 Motor Mounting Bolts and Gear Assembly
11. Carefully remove the motor from the transaxle. Slide the motor away from the transaxle until the motor spline
becomes disengaged from the input shaft, then lift motor out.
See preceding WARNING.
12. If a floor jack was used, pull floor jack from beneath the transaxle and allow the springs to rest on the floor.
13. Remove the U-bolts attaching the transaxle to the leaf springs (Figure 17-10, Page 17-7) .
14. Carefully lift each end of the transaxle off its positioning pin (on the leaf spring) and slide the transaxle to the rear
and out of the vehicle.
15. Drain the lubricant from the transaxle and remove the axle shafts. See Axle Shaft and Oil Seal Removal on
page 17-1. See following NOTE.
NOTE: Recycle or dispose of used oil or lubricant in accordance with local, state, and federal regulations.
16. Remove the brake assemblies if required. See Wheel Brake Assemblies Section.
Appearance of motor may be different from the motor shown
above.
Figure 17-12 Motor Positioning Bolt
2021 Carryall 300 Maintenance and Service Manual Page 17-7