Club Car Carryall 300 2021, Maintenance And Service Manual

Page: 337 / 596

GASOLINE VEHICLE - TROUBLESHOOTING
AND ELECTRICAL SYSTEM Test Procedures
18
TEST PROCEDURE 24 – Voltage at Headlight Socket
See General Warnings on page 1-1.
NOTE: This is a voltage test.
1. If necessary, see Test Basics.
2. Inspect the wires at the light bulb socket. Make sure the wires are securely fastened to the contacts inside the
socket and that wires are installed correctly.
3. Remove the wire harness connector from the headlight bulb.
4. Set the headlight switch to ON.
5. Check for voltage across the two terminals in the connector.
2m
20
m
200
m
2k
200
200
200 200
20
2
200
m
500
20k
200k
2000
k
1000
OFF
WAVETEK 5XL
V
V
V
A
! !
COM
200nA
MAX
1000 ---
750V
FUSED
485
Figure 18-24 Voltage Measurement at Headlight Socket
5.1. If there is battery voltage, check and replace the headlight bulb as necessary..
5.2. If there is no voltage, check the associated wiring, light switch, and 10-amp fuse.
2021 Carryall 300 Maintenance and Service Manual Page 18-39