Club Car Carryall 300 2021, Maintenance And Service Manual

Page: 450 / 596

23
Driven Clutch GASOLINE VEHICLE - CLUTCHES
13. Slide the moveable sheave (16) off the fixed sheave (17).
DRIVEN CLUTCH INSPECTION
1. Inspect the cam for excessive wear. Replace it if necessary.
2. Inspect the drive buttons (2) for excessive wear (Figure 23-18, Page 23-16) . Replace if necessary. To remove
the drive buttons, remove the socket-head cap screws (1) and then the buttons.
2961C
Figure 23-18 Drive Button Inspection
3. Inspect the smooth surface on the fixed and moveable sheaves. Sheaves must be replaced if surfaces are worn
more than 0.060 in. (1.5 mm).
4. Inspect the bronze bearing in the moveable sheave. If the bearing bore diameter is more than 1.384 in. (35.15
mm), the entire moveable sheave must be replaced.
5. Inspect the shaft of the fixed sheave. There should be no noticeable wear. Replace the fixed sheave if it is
worn, scratched or damaged.
6. Inspect the retaining ring. If the outside diameter is more than 1.607 in. (40.82 mm), replace the retaining ring.
DRIVEN CLUTCH ASSEMBLY
1. Place the three drive buttons (2) in position. Apply one drop of Loctite ® 222 to each of the socket-head cap
screws (1) and then install and tighten them to 8 in·lb (0.9 N·m) (Figure 23-19, Page 23-17) .
Page 23-16 2021 Carryall 300 Maintenance and Service Manual