Club Car Carryall 300 2021, Maintenance And Service Manual

Page: 326 / 596

18
Test Procedures
GASOLINE VEHICLE - TROUBLESHOOTING
AND ELECTRICAL SYSTEM
TEST PROCEDURE 15 – Reverse Buzzer and Reverse Buzzer Limit Switch
See General Warnings on page 1-1.
NOTE: Reverse Buzzer: This is a voltage test.
A reverse buzzer is mounted on the back side of the instrument panel. On some models, another reverse buzzer is
also mounted on a bracket at the left rear of the vehicle. The reverse buzzer is powered by the 10-amp ATM fuse.
1. If necessary, see Testing Basics.
2. Remove the instrument panel.
3. Check for proper wiring and tight connections.
4. Turn the key switch to ON.
5. Check that battery voltage is present in the orange/white wire at reverse buzzer.
5.1. If there is no battery voltage, check the 10-amp ATM fuse.
6. Set the Forward/Neutral/Reverse control (FNR) to R.
6.1. If the reverse buzzer does not sound, check the reverse buzzer limit switch.
7. Turn the key switch to OFF.
NOTE: Reverse Buzzer Limit Switch: This is a continuity test.
The reverse buzzer limit switch is located on the FNR. Purple/white and orange wires are connected to it.
1. Disconnect the black/orange wire from the reverse buzzer.
2. Set the FNR to R.
3. Check for continuity between the black/orange wire and ground.
3.1. If there is no continuity, replace the reverse buzzer limit switch.
3.2. If there is continuity, go to the next step.
4. Set the FNR to F.
5. Check for continuity between the black wire and ground.
5.1. If there is continuity, replace the reverse buzzer limit switch.
5.2. If there is no continuity, replace the reverse buzzer..
Page 18-28 2021 Carryall 300 Maintenance and Service Manual