Club Car Carryall 300 2021, Maintenance And Service Manual

Page: 313 / 596

GASOLINE VEHICLE - TROUBLESHOOTING
AND ELECTRICAL SYSTEM Test Procedures
18
TEST PROCEDURE 5 – Key Switch (Engine Kill Circuit) - Pedal-Start Vehicles Only
See General Warnings on page 1-1.
NOTE: This is a continuity test.
1. If necessary, see Testing Basics.
2. Disconnect battery and spark plug wire.
3. Remove the instrument panel. See Instrument Panel Removal.
4. Disconnect the wires from the (+M) and (–M) terminals of the key switch.
5. Set the multimeter to 200 Ohm (1) (Figure 18-4, Page 18-15) .
6. Put the red (+) probe on the (+M) terminal.
2m
20
m
200
m
2k
200
200
200 200
20
2
200
m
500
20k
200k
2000
k
1000
OFF
WAVETEK 5XL
V
V
V
A
! !
COM 200nA
MAX
1000 ---
750V
FUSED
1
–M
2
+M
1
1. 200 Ohm Setting
1337
Figure 18-4 Key Switch Test – Engine Kill Circuit
7. Put the black (–) probe on the (–M) terminal.
8. With the key switch OFF, the reading should be continuity.
8.1. If there is no continuity, replace the key switch.
9. With the key switch ON, the reading should be no continuity.
9.1. If there is continuity, replace the key switch.
10. Connect the wires to the key switch. Make sure wires are connected correctly and are tight. If they are not,
rewire or tighten as necessary.
11. Install the instrument panel. See Instrument Panel Installation.
2021 Carryall 300 Maintenance and Service Manual Page 18-15