type udp ipv4 address
To configure a permanent port in the IP SLA responder for UDP echo or jitter operations, use the
type udp
ipv4 address
command in IP SLA responder configuration mode. To remove the specified permanent port,
use the
no
form of this command.
type udp ipv4 address ip-address port port
no type udp ipv4 address ip-address port port
Syntax Description
Specifies the IPv4 address at which the operation is received.
ip-address
Specifies the port number at which the operation is received. Range is identical
to the one used for the subagent that is, 1 to 65355.
port port
Command Default
If there is no default value, no permanent port is configured.
Command Modes
IP SLA responder configuration
Command History
Modification
Release
This command was introduced.
Release 3.3.0
Usage Guidelines
Task ID
Operations
Task ID
read, write
monitor
Examples
The following example shows how to configure a permanent port for the
type udp ipv4 address
command:
RP/0/0/CPU0:router#
configure
RP/0/0/CPU0:router(config)#
ipsla
RP/0/0/CPU0:router(config-ipsla)#
responder
RP/0/0/CPU0:router(config-ipsla-resp)#
type udp ipv4 address 192.0.2.11 port 10001
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
292
OL-24735-01
IP Service Level Agreement Commands
type udp ipv4 address