Canon iR3245, Service Manual

Page: 91 / 746

Chapter 2
2-23
F-2-90
T-2-3
2.8.2 Turning OFF the Power of the Host Machine
0018-8153
iR3225 / iR3225N / iR3235 / iR3235N / iR3245 / iR3245N
Be sure to refer to "Points to Note When Turning OFF the Main Power" in
installation of the host machine.
2.8.3 Installation Procedure
0018-8098
iR3225 / iR3225N / iR3235 / iR3235N / iR3245 / iR3245N
Installation positions of the reader heaters (2pc.)
Install the reader heater both at the rear left and rear right sides of the reader.
(a total of 2 reader heaters).
F-2-91
1) Open the copyboard cover/DADF
2) Remove the glass retainer (right) [1].
-2 screws [2]
3) Remove the copyboard glass [3].
F-2-92
4) Install the clamp [1].
5) Install the reader heater [2].
- 1 screw (Binding; M4X6) [3]
6) Connect the connector [4] of the reader heater and secure the harness of
the reader heater with the clamp [1].
Rear right side of the reader (enlarged)
F-2-93
7) Move the CCD unit [1] to the far left.
8) Install the 2 clamps [2].
9) Install the reader heater [3].
-1 screw (Binding; M4X6) [4]
10) Connect the connector [5] of the reader heater and secure the harness of
the reader heater with the 2 clamps [2].
Rear left side of the reader (enlarged)
No. Name Part No. Qty.
[1] Reader Heater FK2-0228-000 2 pc.
[2] Clamp WT2-0507-000 3 pc.
[3] Screw (Binding M4X6) XB1-2400-609 2 pc.
[4] Screw (TP; M3X6) XB6-7300-607 1 pc.
[5] Environment switch unit FM3-7052-000 1 pc.
[6] AC driver PCB FM3-5085-000 1 pc.
MEMO:
The 2 reader heaters are identical.
They can be installed either at left or right side.
[1]
[3] [2]
[5]
[6]
[4]
[5]
When removing the copyboard glass, be sure not to put your fingers on the
glass surface and the white plate at the back (soil causes black lines on
image).
Be sure to clean soil with lint-free paper moistened with alcohol if soil is
attached.
[1] [2] [2]
[3]
[1]
[2] [3]
[4]