Canon iR3245, Service Manual

Page: 431 / 746

Chapter 14
14-3
4) Loosen the screw [2] on the adjustment plate [1]. (Figure shows the cas-
sette 1.)
5) Move the adjustment plate [1] toward front or back and tighten the screw
[2].
If moving the plate toward front by 1 scale: Left image margin decreases
by 1mm.
If moving the plate toward back by 1 scale: Left image margin increases
by 1mm.
F-14-8
6) Make a print from the adjusted pickup cassette and check that the left mar-
gin is within the standard.
B. In case of manual feed tray pickup
1) Open the manual feed tray.
2) Move the tab [1] in the direction of the arrow and remove the side guide
plate stopper [2].
3) Loosen the 2 screws [3] on the manual feed tray upper cover.
4) Move the manual feed tray upper cover [4] toward front or back and tight-
en the 2 screws [3].
If moving the plate toward front: Image left margin decreases.
If moving the plate toward back: Image left margin increases.
F-14-9
5) Make a print from the manual feed tray and check that the left margin is
within the standard.
C. In case of paper deck pickup
1) Make sure that the 4 pedestal adjusters contact to the floor.
F-14-10
2) Pull out the paper deck storage.
3) Disengage the paper deck from the host machine.
4) Adjust the position of the latch holding plate [1] on the deck open solenoid
by loosening the 2 screws [2].
Use the latch holding plate scale [3] for the reference of adjustment.
F-14-11
5) Make a print from the paper deck and check that the left margin is within
the standard.
[1]
[1]
[1] [3] [2]