Canon iR3245, Service Manual

Page: 339 / 746

Chapter 10
10-37
10.5.22.2 Removing the Right Cover
0018-9970
iR3225 / iR3225N / iR3235 / iR3235N / iR3245 / iR3245N
(Perform the same procedure from step 1 to 5 as in 'Releasing the Right Cov-
er'.)
(page 10-36)
Reference[Releasing the Right Cover]
1) Remove the 2 shafts [5].
- 1 connector [1]
- 1 reuse band [2]
- 1 wire saddles [3]
- 3 screws [4]
F-10-110
2) While releasing the hinge, remove the right cover [1].
F-10-111
Points to Note When Installing the Right Cover
Be sure to fit the claws (protrusion) at the end plate of the host machine in
the corresponding holes of the hinges and then tighten the screws.
If not, the right cover may not correctly close.
The double hinge is employed for the right cover of the equipment.
Accordingly, cautions must be taken when installing the right cover; and
therefore, the following caution label is affixed to the end plate of the host
machine.
[1]
[2]
[1] Fit the claw to the hole.
[2] Tighten with screws.
How to Install the Right Cover
1) Fit the hinge [1] at the lower part of the right cover in the boss.
2) Hook the hinge [2] at the upper part of the right cover on the hook at the
end plate of the host machine.
[2]
[3]
[5]
[1]
[4]
[4]
[5]
[1]