Canon iR3245, Service Manual

Page: 703 / 746

Chapter 18
18-9
18.2.3 Making Connections (SST in use)
0019-0048
iR3225 / iR3225N / iR3235 / iR3235N / iR3245 / iR3245N
You are now ready to connect the PC to the machine.
Preparatory Work
Items to Prepare:
- PC to which the SST (version 4.02 or later) and the system software for the machine
- Twisted pair cross cable
10Base-T: Category 3 or 5
100Base-TX: Category 5
1000Base-T: Enhanced Category 5 (CAT5e) or higher
Procedure
1) Start up the PC.
2) Check the network settings of the PC.
2-1) At the command prompt, type 'IPCONFIG', and press the Return key.
2-2) Make sure that the network setting is as below.
IP address: 172.16.1.160
subnet mask: 255.255.255.0
default gateway: any
If the settings are not as indicated below, make the appropriate changes:
F-18-13
3) Check to see that the Execute/Memory lamp on the control panel is off, and turn off the power of the machine as described below.
3-1) Hold down the power switch on the control panel for 3 sec or more.
3-2) Shut down the machine by following the instruction on the control panel.
The main power switch will turn off automatically.
If a USB device is connected, make sure to remove it.
When the machine recognizes a USB device, it does not make a communication with SST; thus, USB device and SST cannot be used simultaneously.
Do not use the following IP address:
- 172.16.1.0
- 172.16.1.100
- 172.16.1.255
C: \
W i n d o w s 2 0 0 0 I P C o n f i g u r a t i o n
M i c r o s o f t W i n d o w s 2 0 0 0 [ Ve r s i o n 5 . 0 0 . 2 1 9 5 ]
( C ) C o p y r i g h t 1 9 8 5 - 1 9 9 9 M i n c r o s o f t C o r p .
E t h e r n e t a d a p t e r L o c a l A r e a C o n n e c t i o n :
C o n n e c t i o n - s p e c i f i c D N S S u f f i x . :
I P A d d r e s s . . . . . . . . . . . . : 1 7 2 . 1 6 . 1 . 1 6 0
S u b n e t M a s k . . . . . . . . . . . : 2 5 5 . 2 5 5 . 2 5 5 . 0
D e f a u l t G a t e w a y . . . . . . . . . :
C : \
C : \ i p c o n f i g
Command Prompt