Canon iR3245, Service Manual

Page: 116 / 746

Chapter 2
2-48
F-2-206
19) Insert the power plug into the power outlet.
20) Turn on the main power switch.
21) Check to see that the voice operation board is recognized.
123 key (Counter Check key) > [Device Configuration]
When 'voice operation' is displayed, the functions are enabled.
2.16.5 Checking the Settings
0019-9933
iR3225 / iR3225N / iR3235 / iR3235N / iR3245 / iR3245N
After turning on the power supply of the host machine, check the following
settings to use the voice operation kit.
1) [Additional Function] > [Voice Navigation Settings] > [Voice Recogni-
tion Settings]
Check to see that it is set to ON.
2.16.6 Operation Check
0019-9934
iR3225 / iR3225N / iR3235 / iR3235N / iR3245 / iR3245N
<To use>
1) Press the reset key or voice recognition button[1] for 3 sec or more.
F-2-207
2) Select Voice the Navigation Selection [ Voice Guide + Recognition /
Voice Guide / Voice Recognition ] on the control panel screen and hold
down OK.
3) 'Voice operation kit' becomes available to use if the copy count display on
the screen is framed in red.
<To stop>
1) Press the reset key or Voice Recognition button for 3 sec or more.
2.17 Installing the Wireless Network Interface
Adapter
2.17.1 Notice At Installation
0019-4464
iR3225 / iR3225N / iR3235 / iR3235N / iR3245 / iR3245N
2.17.2 Checking the Contents
0018-9714
iR3225 / iR3225N / iR3235 / iR3235N / iR3245 / iR3245N
<Wireless LAN Board-A1>
F-2-208
< CD/Guides >
- Wireless LAN User's Guide
- Manual CD (Wireless LAN User's Guide)
- FCC/IC instruction sheet (included only for the USA area)
2.17.3 Turning OFF the Power of the Host Machine
0018-9613
iR3225 / iR3225N / iR3235 / iR3235N / iR3245 / iR3245N
Be sure to refer to "Points to Note When Turning OFF the Main Power" in
installation of the host machine.
If there is not a sufficient memory, the functions are not enabled even with
the board connected.
MEMO:
When it is set to on, each confirmation screen at copy start, resetting, and
calling the mode memory by voice operation is displayed.
[1]
[2]
[3]
[1]
If 'voice operation kit' does not function normally, check the following
points.
- The item 'TTS-JA/TTS-EN, ASR-JA/ASR-EN' has been installed in service
mode > COPIER > Display > VERSION.
Install the equipment after installing the Expansion Bus-E1.
[1] Wireless LAN board 1pc.
[2] MFP antenna 1pc.
[3]*1 Cord guide 6pc.
[4]*2 Antenna affixing tape 1sheet.
[5] Wireless LAN display label 1pc.
*1; Use 4 pieces for the host machine.
*2; Keep the remaining tape from the 3 sheets in a safe place for later use.
[1] [2]
[3]
1
[4]
2
[5]