Canon iR3245, Service Manual

Page: 105 / 746

Chapter 2
2-37
10) Set the connector [2] of the heater to the panel mount [1].
F-2-152
11) Remove the screw [2] to remove the blanking plate [1] attached on the
power cord mount of the paper deck.
F-2-153
12) Connect the AC inlet connector [1].
13) Attach the grounding wire [2].
- Screw with washer [3], 1 pc.
F-2-154
14) Attach the harness [1] to the rear end plate of the paper deck.
- Screw (M4X8) [2], 2 pc.
F-2-155
15) Wrap the harness [1] around the cable guide [2] on the power cord
mount. (One and a half turn)
F-2-156
16) Connect each of the connectors at both ends of the harness unit to the
heater connector and the AC power supply connector respectively.
17) Attach the external cover of the paper deck in the following orders.
[1] Upper cover (Make sure that the cable is not stuck in) (M4X8; 2
screws)
[2] Upper front cover (Connect the connector) (M4X8; 3 screws)
[3] Rear cover (M3X8; 2 screws, M4X8; 4 screws)
[4] Right cover (M4X8; 3 screws)
18) Slide the paper deck in the left direction and set it to the host machine.
19) Connect the paper deck connector [1] to the rear surface of the host ma-
chine.
F-2-157
[2]
[1]
[1]
[2]
[3]
Insert
Insert
[2]
[2]
[1]
[2]
[2]
[1]
[1] [1]