BEST ACCESS SYSTEMS B.A.S.I.S. V, Service Manual

Page: 275 / 290

Installation Instructions for B.A.S.I.S. EX Series Exit Hardware Trim
BEST ACCESS SYSTEMS
Indianapolis, Indiana
3
Installation Instructions for B.A.S.I.S. EX Series Exit Hardware Trim
Preparing the door
3
Position trim template and mark drill
points
1 For new installations
a Cut the G08 Template—Installation Template for
EXG & EXBV Exit Hardware Trim for Use with Precision
Hardware 1000/2000 Series Locks or G07
Template—Installation Template for EXG & EXBV Exit
Hardware Trim for Use with Von Duprin 98/99 Series
Locks along the dashed lines.
b Align the horizontal and vertical arrows marked on
the template with the centerlines marked on the
door. See Figure 1.
For retrofit installations
Align the mounting holes for the escutcheon and
lock stile case marked on the template with the
mounting holes in the door. See Figure 1.
Note: The B.A.S.I.S. outside escutcheon is mounted
using the four lock stile case mounting holes
(‘A’ holes); these holes must be 7/16
″
in diameter and
drilled completely through the door.
2 Tape the template to the door.
3 Center punch the necessary drill points. Refer to the
instructions on the template.
4
Mortise for mortise case and faceplate
(mortise exit devices only)
Note: If retrofitting the B.A.S.I.S. trim to an existing exit
hardware installation, skip this task.
Mortise the edge of the door for the mortise case and
faceplate; follow the instructions provided by the exit
hardware manufacturer.
Figure 1 Positioning the B.A.S.I.S. trim template
Trim template
Horizontal centerline
of lock
Vertical centerline
of lock
Outside of door