Servicing Standard Outside Escutcheon Parts
9–6
B.A.S.I.S. V Service Manual
S
ERVICING
THE
SENSOR
HARNESS
Replacement kits are available for the sensor harness and the
conversion harness. See
page 4–6
.
These steps are for EV, FV, and LV function mortise locks only.
Note:
For a description of lock functions, see
page 2–2
.
Removing the
sensor harness
1. Remove the following parts:
■
inside and outside escutcheons. For mortise lock instructions,
see
page 5–3
. For cylindrical lock instructions, see
page 7–5
.
■
escutcheon gasket (
page 9–2
)
■
harness clamp (
page 9–4
).
2. Disconnect the sensor harness from the electronics board.
Reinstalling the
sensor harness
1. Connect the sensor harness to the J4 connector on the electronics
board.
2. Reinstall the following parts:
■
harness clamp (
page 9–4
)
■
escutcheon gasket (
page 9–2
)
■
inside and outside escutcheons. For mortise lock instructions, see
page 5–6
. For cylindrical lock instructions, see
page 7–8
.
Figure 9.5
Removing and reinstalling the sensor harness
(smart card reader shown)
Outside escutcheon
Sensor harness connector
(J4)
Summary of Contents for B.A.S.I.S. V
