BEST ACCESS SYSTEMS B.A.S.I.S. V, Service Manual

Page: 183 / 290

Servicing Exit Hardware Trim Escutcheon Parts
B.A.S.I.S. V Service Manual 10–9
S
ERVICING THE LENS COVERS
A replacement kit is available for the lens covers. See page 4–6 .
Each time you service the lens covers you need to replace the following
parts with new parts:
■
escutcheon gasket (C64564)
■
cable tie
■
lift finger screw ( page 4–9 )
■
mounting plate screws ( page 4–9 ).
Removing the lens
covers
1. Remove the following parts:
■
escutcheon from the door ( page 8–13 )
■
mounting standoffs ( page 10–2 )
■
escutcheon gasket ( page 10–3 )
■
lift finger ( page 10–4 )
■
mounting plate ( page 10–6 )
2. Perform step 2 on page 9–3 .
Reinstalling the lens
covers
1. Perform steps 1 and 2 on page 9–3 .
2. Reinstall the following parts:
■
mounting plate ( page 10–7 )
■
escutcheon gasket ( page 10–3 )
■
lift finger ( page 10–5 )
■
mounting standoffs ( page 10–2 )
■
escutcheon on the door ( page 8–14 ).
S
ERVICING THE PRIMARY HARNESS
A replacement kit is available for the primary harness. See page 4–10 .
Each time you service the primary harness you need to replace the
following parts with new parts:
■
escutcheon gasket (C64564)
■
cable tie
■
lift finger screw ( page 4–9 )
■
mounting plate screws ( page 4–9 )
■
tape for mounting the sounder.
Caution
B efore you handle the control electronics board or any component
on the control electronics board, make sure that you are properly
grounded using an electrostatic discharge (ESD) protection kit.
Touching the control electronics board without proper grounding can
damage sensitive electronic components—even if you don’t notice
any static discharge.