Multicast Routing
Left running head:
Chapter name (automatic)
552
Beta
Beta
CLI Configuration Guide
Alcatel-Lucent
PIM C
ONFIGURATION
C
OMMANDS
To configure PIM, perform the tasks described in the following sections. The tasks
in the first section are required; the tasks in the remaining sections are optional,
but might be required for your network.
T
O
E
NABLE
M
ULTICAST
R
OUTING
E
XAMPLE
ALU(config)# ip multicast-routing
T
O
E
NABLE
PIM
ON
AN
I
NTERFACE
E
XAMPLE
ALU(config-if GigabitEthernet3/0)# ip pim sparse-mode
Command (in CM)
Description
ip multicast-routing
This command enables multicast routing
and forwarding on OA-700.
Multicast routing is disabled by default.
Command (in ICM)
Description
ip pim sparse-mode
Enter this command in the Interface
Configuration Mode.
This command is used to enable PIM on
an interface.
After enabling this command, PIM starts
sending hello packets to form
neighborship.
no ip pim sparse-mode
This command is used to disable PIM on
an interface.
Summary of Contents for OmniAccess 700
