Alcatel-Lucent OmniAccess 700, Cli Configuration Manual

Page: 341 / 1193

PPP Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
315
Alcatel-Lucent
Beta Beta
CLI Configuration Guide
Example:
ALU(config)#interface Serial0/0
ALU(config-if Serial0/0)#
For more details on configuring a Serial interface (V.35/X.21), refer to the “Universal
Serial Port (USP) Line Card” chapter.
Step 6: Enter the Serial interface configuration mode
ALU(config)# interface Serial <slot/port:channel>
ALU(config-if Serial <slot/port:channel> )#
Example:
ALU(config)#interface Serial0/0:0
ALU(config-if Serial0/0:0)#
Step 7: Administratively bring up the interface
ALU(config-if < interface-name >)# no shutdown
Example:
ALU(config-if Serial0/0:0)# no shutdown
Step 8: Configure IP address for the interface
ALU(config-if < interface-name >)# ip address { <ip-
address subnet-mask>|<ip-address/prefix-length> }
Example:
ALU(config-if Serial0/0:0)# ip address 20.20.20.20/24
Step 9: Set encapsulation to PPP on the interface. See “To Set PPP
Encapsulation on an Interface”
Step 10: Configure PPP Optional Parameters . See “PPP Optional
Parameters”
•
Configure LCP parameters. See “Link Control Protocol Configuration”
•
Configure IPCP parameters. See “IP Control Protocol (IPCP)
Configuration”
•
Configure Timers and Counters. See “PPP Counters and Timers
Configuration”
•
Configure authentication through user name and password. See “PPP
Authentication Configuration”
Step 11: Use the “PPP Show Commands” to view PPP configuration.