Alcatel-Lucent OmniAccess 700, Cli Configuration Manual

Page: 181 / 1193

Ethernet Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
155
Alcatel-Lucent
Beta Beta
CLI Configuration Guide
E
THERNET
C
ONFIGURATION
Refer to the following sections to configure an Ethernet interface on the OA-700.
E
THERNET
I
NTERFACE
C
ONFIGURATION
S
TEPS
This section lists the step by step instructions to configure Ethernet interface.
Step 1: Enter into Configuration Mode.
ALU# configure terminal
ALU(config)#
Step 2: Configure Gigabit Ethernet interface. See “To Configure GigE Interface”
Step 3: Administratively bring up the interface.
ALU(config-if < interface-name >)# no shutdown
Example:
ALU(config-if GigabitEthernet7/0)# no shutdown
Step 4: Configure IP address for the interface.
ALU(config-if < interface-name >)# ip address { <ip-
address subnet-mask>|<ip-address/prefix-length> }
Example:
ALU(config-if GigabitEthernet7/0)# ip address
20.20.20.20/24
Step 5: Configure parameters that are optional on the interface.
•
Configure Duplex Operation on the interface. See “To Configure Duplex
Operation”
•
Configure Flow control on the interface. See “To Configure Flow Control”
•
Configure MTU on the interface. See “To Configure MTU (Maximum
Transmission Unit) on the Interface”
•
Configure Speed on the interface. See “To Configure Speed”
Step 6: View the configuration details on the interface. See “Ethernet Interface
Show Commands” .
Step 7: Clear interface statistics. See “Ethernet Interface Clear Commands” .