Alcatel-Lucent OmniAccess 700, Cli Configuration Manual

Page: 509 / 1193

RIP Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
483
Alcatel-Lucent
Beta Beta
CLI Configuration Guide
T
O
C
ONFIGURE
RIP A
UTHENTICATION
M
ODE
E
XAMPLE
ALU(config-if GigabitEthernet7/0)# ip rip authentication mode
md5
ALU(config-if GigabitEthernet7/0)# no ip rip authentication
mode
T
O
D
ISABLE THE
V
ALIDATION OF
S
OURCE
IP A
DDRESS
By default, the router verifies whether the incoming RIP updates originate from an
address on the same IP subnet as the interface it is received on. To disable this
behavior, use the following command in the Router Configuration mode.
E
XAMPLE
ALU(config-router rip)# no validate-update-source
ALU(config-router rip)# validate-update-source
Command (in ICM) Description
ip rip authentication mode
{ md5 | text }
Use the following command in the
Interface
Configuration mode.
This command is used to configure the
authentication mode to be used by the
interface (or let it default mode).
The default authentication mode is
Plain Text authentication.
no ip rip authentication mode
The ‘no’ command sets the
authentication mode to its default, i.e,
plain Text authentication.
Command (RCM mode) Description
no validate-update-source
Disables the validation of the source IP
address of the incoming RIP routing
updates.
By default, RIP validates the source IP
address of incoming RIP routing
updates.
validate-update-source
This command validates the source IP
address of incoming RIP routing
updates.