Alcatel-Lucent OmniAccess 700, Cli Configuration Manual

Page: 274 / 1193

T1E1 Line Card
Left running head:
Chapter name (automatic)
248
Beta Beta
CLI Configuration Guide
Alcatel-Lucent
T
O
C
ONFIGURE
L
INECODE
The E1 service provider determines the linecode type, whether ami or hdb3 is
required for your E1 circuit.
Note: If ‘ami’ linecode is configured, configure timeslot speed to 56Kbps to ensure ones
density.
E
XAMPLE
The following example sets the line code type for E1 to ami:
ALU(config-controller E1)# linecode ami
The following example sets the line code type for E1 to hdb3:
ALU(config-controller E1)# no linecode
T
O
S
ET A
C
LOCKSOURCE ON
E1
E
XAMPLE
The following example configures the E1 0 clocksource to line:
ALU(config-controller E1)# clocksource line
The following example configures the E1 0 clocksource to internal:
ALU(config-controller E1)# no clocksource
Command (in CCM) Description
linecode { ami | hdb3 }
This command is used to set a Line
Encoding for the E1 interface.
no linecode
The “ no ” command sets the linecode to
its default.
The default linecode value is HDB3.
Command (in CCM) Description
clocksource { internal | line }
This command is entered in the
controller configuration mode to set
clocksource for E1 interface. The
keyword "
clocksource " is used to
configure clock signals.
no clocksource
The “ no ” keyword sets the clocksource
to its default.
The default value for clocksource is
internal.