Alcatel-Lucent OmniAccess 700, Cli Configuration Manual

Page: 952 / 1193

Quality of Service
Left running head:
Chapter name (automatic)
926
Beta Beta
CLI Configuration Guide
Alcatel-Lucent
Q
O
S C
ONFIGURATION
This section includes the following:
•
“QoS Configuration Steps”
•
“QoS Configuration Flow”
•
“QoS Configuration Commands”
Q
O
S C
ONFIGURATION
S
TEPS
You can configure QoS on OA-700 by any of the following procedures:
•
Auto QoS procedure
•
Standard procedure
Auto QoS Procedure:
Step 1: Enter into the Interface Configuration Mode
ALU(config)# interface < name >
Example:
ALU(config)# interface GigabitEthernet7/0
ALU(config-if GigabitEthernet7/0)#
Note: 1. Auto QoS can be configured on Gigabit Ethernet, Serial, Frame Relay (FR),
Multilink Point to Point (MLPPP), Multilink Frame Relay (MLFR), and VLAN interfaces.
To view QoS on Frame Relay interface and sub interface configuration, see “QoS on
FR and FR Sub Interface” section in this chapter.
2. Auto QoS cannot be configured on tunnel interface.
Step 2: Administratively bring up the interface
ALU(config-if < interface-name >)# no shutdown
Example:
ALU(config-if GigabitEthernet7/0)# no shutdown
Step 3: Configure IP address for the interface
ALU(config-if < interface-name >)# ip address { <ip-
address subnet-mask>|<ip-address/prefix-length> }
Example:
ALU(config-if GigabitEthernet7/0)# ip address
20.20.20.20/24
Step 4: Configure Auto QoS. See “Auto QoS Configuration”