Alcatel-Lucent OmniAccess 700, Cli Configuration Manual

Page: 872 / 1193

Generic Routing Encapsulation
Left running head:
Chapter name (automatic)
846
Beta Beta
CLI Configuration Guide
Alcatel-Lucent
T
O
C
ONFIGURE
D
ESTINATION
IP A
DDRESS FOR THE
T
UNNEL
E
XAMPLE
ALU(config-if Tunnel7)# tunnel destination 10.1.0.5
ALU(config-if Tunnel7)# no tunnel destination 10.1.0.5
T
O
S
ET THE
T
UNNEL
DF-BIT
E
XAMPLE
ALU(config-if Tunnel7)# tunnel df-bit clear
T
O
R
ESOLVE
T
UNNEL
S
OURCE AND
D
ESTINATION FROM A
D
IFFERENT
VRF
When a VRF is associated with a tunnel, the source and the destination is
resolved from the VRF associated with the tunnel interface. That means, source
and destination of a tunnel should belong to the same VRF.
This command allows you to deploy VRF-lite solution with a single WAN link.
E
XAMPLE
ALU(config-if Tunnel7)# tunnel vrf ALU-vrf1
Command (in ICM) Description
tunnel destination < ip-
address>
This command sets the destination IP
address of the tunnel at the remote end.
no tunnel destination < ip-
address>
The “no” command removes the
configured destination IP address.
Command (in ICM) Description
tunnel df-bit { clear | set | copy-
from-inner-ip }
This command sets the value of the DF-
bit for the Outer-IP header.
The default DF-BIT value is ‘clear’.
Command (in ICM) Description
tunnel vrf { <vrf-name>
| default }
This command allows to resolve the
tunnel source and tunnel destination
from the specified VRF instead of the
VRF associated with the tunnel
interface.