Alcatel-Lucent OmniAccess 700, Cli Configuration Manual

Page: 183 / 1193

Ethernet Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
157
Alcatel-Lucent
Beta Beta
CLI Configuration Guide
E
THERNET
I
NTERFACE
C
ONFIGURATION
C
OMMANDS
This section provides an expansive view on the commands that are used in
configuring the Ethernet Interfaces.
T
O
C
ONFIGURE
G
IG
E I
NTERFACE
E
XAMPLE
The following example shows configuring GigE interface:
ALU(config)# interface GigabitEthernet 7/0
ALU(config-if GigabitEthernet7/0)#
T
O
C
ONFIGURE
D
UPLEX
O
PERATION
E
XAMPLE
ALU(config-if GigabitEthernet7/0)# duplex full
ALU(config-if GigabitEthernet7/0)# no duplex
T
O
C
ONFIGURE
F
LOW
C
ONTROL
E
XAMPLE
ALU(config-if GigabitEthernet7/0)# flowcontrol send on
ALU(config-if GigabitEthernet7/0)# no flowcontrol send on
Command (in CM) Description
interface GigabitEthernet
< slot/port>
This command allows you to configure
GigE interface.
Command (in ICM) Description
duplex { auto | full | half }
This command configures duplex
operation on an interface.
no duplex
The “no” command sets the duplex
mode to its default.
The default duplex mode is “ auto” .
Command (in ICM) Description
flowcontrol { receive | send }
{ off | on }
This command configures flow control
on a GigE interface.
no flowcontrol { receive | send }
{ off | on }
The “no” command sets the flow control
to its default. By default, flow control is
set to “
Off ”.