Alcatel-Lucent OmniAccess 700, Cli Configuration Manual

Page: 502 / 1193

Routing Information Protocol
Left running head:
Chapter name (automatic)
476
Beta Beta
CLI Configuration Guide
Alcatel-Lucent
T
O
E
NABLE
/D
ISABLE
B
ROADCAST
U
PDATES
In RIP Version 2, routing updates are sent to multicast address. You can change
this behavior by enabling the following command.
E
XAMPLE
ALU(config-if GigabitEthernet7/0)# ip rip v2-broadcast
ALU(config-if GigabitEthernet7/0)# no ip rip v2-broadcast
T
O
C
ONFIGURE
P
ASSIVE
I
NTERFACES
The " passive interface " command can be issued under RIP to make the OA-700
system a silent host on the specified data link. Like other hosts, it listens to the
RIP broadcasts on the link and updates the routing table accordingly.
E
XAMPLE
ALU(config-router rip)# passive-interface GigabitEthernet 7/0
ALU(config-router rip)#no passive-interface GigabitEthernet 7/0
Command (in ICM) Description
ip rip v2-broadcast
Use this command to send routing
updates to broadcast address.
This command is used to allow RIP
Version 2 update packets to be sent as
broadcast packets instead of multicast
packets.
no ip rip v2-broadcast
The ‘no’ command disables sending of
routing updates to broadcast address.
Command (in RCM) Description
passive-interface {< interface-
name> | default }
This command is used to control the set
of interfaces with which you want to
exchange routing updates.
no passive-interface
{< interface-name> | default }
The ‘no’ command disables the
configured passive interfaces.