Alcatel-Lucent OmniAccess 700, Cli Configuration Manual

Page: 286 / 1193

T1E1 Line Card
Left running head:
Chapter name (automatic)
260
Beta Beta
CLI Configuration Guide
Alcatel-Lucent
T
O
C
ONFIGURE
C
HANNELIZED
T1
The controller can be channelized. This implies that more than one channel-group
can be configured on a controller.
Note: You can configure only 20 channel-groups per card.
The following example configures a channel group on controller T1 at the first slot
and at the 0th port:
E
XAMPLE
1. Variations of the channel-group to associate different timeslots with the
serial interface are shown:
To associate all the timeslots with the controller:
ALU(config-controller T1)#channel-group 0 timeslots 1-24
To associate contiguous timeslots with the controller:
ALU(config-controller T1)#channel-group 0 timeslots 1-10
ALU(config-controller T1)#channel-group 0 timeslots 1,2,3
To associate non-contiguous timeslots with the controller:
ALU(config-controller T1)#channel-group 0 timeslots 1,4,20
2. In the above example, the channel-group command is shown only with a
value of ‘0’. The following example uses value in the range of 0-23:
Command (in CCM) Description
channel-group < 0 -23> timeslots
<1-24> speed [ 56K | 64K ]
This command is entered in the
controller configuration mode to create
channel-groups that vary from 0-23 and
set timeslots that vary from 1-24.
The default speed is 64 Kbps.
no channel-group < 0 -23>
This command removes the channel-
groups configured on the controller.