Alcatel-Lucent OmniAccess 700, Cli Configuration Manual

Page: 427 / 1193

LFI Configuration on FR
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
401
Alcatel-Lucent
Beta Beta
CLI Configuration Guide
LFI C
ONFIGURATION ON
FR S
UB
I
NTERFACE
LFI can also be configured on a Frame Relay sub-interface.
For configuring LFI on a FR sub-interface, follow the steps given below:
Step 1: Repeat the steps Step 1 to Step 7 as given in the section “LFI - FR
Configuration Steps”
Step 2: Configure sub-interface on a serial interface.
ALU(config)# interface Serial < slot/
port:channel.subchannel>
ALU(config-if Serial < slot/port:channel.subchannel> )#
Example:
ALU(config)# interface Serial 0/0:0.1
ALU(config-if Serial0/0:0 . 1)#
Step 3: Configure IP address for the sub-interface
ALU(config-if Serial < slot/port:channel.subchannel> )#
ip address { <ip-address subnet-mask>|<ip-address/
prefix-length> }
Example:
ALU(config-if Serial0/0:0 . 1)# ip address 124.123.10.1
255.255.255.0
Step 4: Repeat 10 to 13 as given in the section “LFI - FR Configuration Steps”
Note: If you are configuring FR on a sub-interface on a Serial interface (V.35/X.21),
configure a sub-interface using the following command:
ALU(config)# interface Serial <slot/port>.subchannel
ALU(config-if Serial <slot/port.subchannel> )#
Example:
ALU(config)#interface Serial0/0.1
ALU(config-if Serial0/0.1)#