Alcatel-Lucent OmniAccess 700, Cli Configuration Manual

Page: 392 / 1193

Multilink Frame Relay
Left running head:
Chapter name (automatic)
366
Beta Beta
CLI Configuration Guide
Alcatel-Lucent
Example:
ALU(config)#interface Serial0/0
ALU(config-if Serial0/0)#
For more details on configuring a Serial interface (V.35/X.21), refer to the “Universal
Serial Port (USP) Line Card” chapter.
Bundle Configuration
Step 6: Configure MLFR Bundle Interface. See “To Configure MLFR Bundle
Interface”
Step 7: Administratively bring up the interface.
ALU(config-if < interface-name >)# no shutdown
Example:
ALU(config-if mlfr100)# no shutdown
Step 8: Configure IP address for the interface
ALU(config-if < interface-name >)# ip address { <ip-
address subnet-mask>|<ip-address/prefix-length> }
Example:
ALU(config-if mlfr100)# ip address 20.20.20.20/24
Step 9: Configure Frame Relay LMI (Local Management Interface) type. See “To
Configure Local Management Interface (LMI) Type” (Optional)
Step 10: Configure Data Link Connection Identifiers (DLCI) on the interface. See
“To Configure Data-link Connection Identifier (DLCI)”
Step 11: Assign a Bundle Identification (BID) name to the MLFR bundle
configured above. See “To Assign Bundle Identification (BID) to the Bundle”
(Optional)
Member Link Configuration
Step 12: Enter Serial interface configuration mode
ALU(config)# interface Serial <slot/port:channel>
ALU(config-if Serial <slot/port:channel> )#
Example:
ALU(config)#interface Serial0/0:0
ALU(config-if Serial0/0:0)#
Step 13: Administratively bring up the interface
ALU(config-if < interface-name >)# no shutdown
Example:
ALU(config-if Serial0/0:0)# no shutdown