Alcatel-Lucent OmniAccess 700, Cli Configuration Manual

Page: 587 / 1193

IGMP Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
561
Alcatel-Lucent
Beta Beta
CLI Configuration Guide
IGMP C
ONFIGURATION
This section includes the following:
•
“IGMP Configuration Steps”
•
“IGMP Configuration Flow”
•
“IGMP Configuration Commands”
•
“Show Commands in IGMP”
IGMP C
ONFIGURATION
S
TEPS
The steps given below helps in configuring IGMP routing on the OA-700.
Step 1: Configure an interface. Enter Interface Configuration Mode.
ALU(config)# interface < name >
Example:
ALU(config)# interface GigabitEthernet3/0
ALU(config-if GigabitEthernet3/0)#
Note: IGMP can be configured on Layer 3 interfaces.
Step 2: Administratively bring up the interface
ALU(config-if < interface-name >)# no shutdown
Example:
ALU(config-if GigabitEthernet3/0)# no shutdown
Step 3: Configure IP address for the interface
ALU(config-if < interface-name >)# ip address { <ip-
address subnet-mask>|<ip-address/prefix-length> }
Example:
ALU(config-if GigabitEthernet3/0)# ip address
20.20.20.20/24
Step 4: Enable Multicast routing. See “To Enable Multicast Routing”
Step 5: Enable IGMP on an interface:. See “To Enable IGMP on an Interface”