IP Security - Virtual Private Network
Left running head:
Chapter name (automatic)
812
Beta
Beta
CLI Configuration Guide
Alcatel-Lucent
T
O
C
ONFIGURE
M
ODE
ON
A
T
UNNEL
I
NTERFACE
E
XAMPLE
ALU(config-if Tunnel1)# mode ipsec
T
O
C
ONFIGURE
S
OURCE
IP A
DDRESS
FOR
THE
T
UNNEL
E
XAMPLE
ALU(config-if Tunnel1)# tunnel source 2.2.2.1
or
ALU(config-if Tunnel1)# tunnel source GigabitEthernet7/0
ALU(config-if Tunnel1)# no tunnel source 2.2.2.1
or
ALU(config-if Tunnel1)# no tunnel source GigabitEthernet7/0
Command (in ICM)
Description
mode
{
gre
|
ipsec
}
This command is used to set the mode
on tunnel interface.
To configure IPsec tunnel interface, set
the mode to IPsec.
Note:
By default, tunnel is
configured in GRE mode.
Command (in ICM)
Description
tunnel
source
{
<ip-address>|
<interface-name>
}
This command sets the source IP
address of the tunnel.
no tunnel
source
{
<ip-address>
|<interface-name>
}
The “no” command removes the
configured source IP address of the
tunnel.
Summary of Contents for OmniAccess 700
