Alcatel-Lucent OmniAccess 700, Cli Configuration Manual

Page: 669 / 1193

Modifying NAT Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
643
Alcatel-Lucent
Beta Beta
CLI Configuration Guide
T
O
C
HANGE THE
R
ULE
/L
INE
N
UMBERS
To change the rule/line number of a pre-defined match-list, use the “ change ”
keyword. This allows yo to just change the line number and not to swap between
two numbers. This command changes the order of a rule to the new number
position.
E
XAMPLE
Consider the following example:
ip nat N1
10 match M1 source-nat
20 match M2 source-nat
30 match M3 source-nat
40 match M4 source-nat
In the above sequence, if m4 has a priority 40. Use the “change“ keyword to
change the priority of m4.
ALU(config-nat-N1)# change 40 25
To view the NAT configuration after changing the priority, use the show command.
The output appears as shown:
ip nat N1
10 match M1 source-nat
20 match M2 source-nat
25 match M4 source-nat
30 match M3 source-nat
Now, to generate a numbering scheme with a proper order, use the keyword
“
renumber ” as explained in the section “To Renumber the List” .