ABB TCC300, User Manual, Page: 426 / 716

GUID-6C74AD06-67C3-433B-B783-6A218088FA6D V1 EN
Figure 344: Configuration Dialog Screen
4. Select "Follower" From the "Master/Follower Configuration" section of the
"Configuration" dialog screen.
5. Enter the desired Master/Follower Configuration Settings from the "Master/
Follower Configuration Settings" section of the "Configuration" dialog screen:
•
Paralleling Address (1 to 16) – The Follower Paralleling Address must be a
value less than the Master. The control’s position in the paralleling network is
determined by its paralleling address. As shown in
Figure 339 , Position 1
should be assigned a paralleling address of 1, Position 2 a paralleling address
of 2 and so on, in an ascending order. In this example the Master control will
be in Position 8 with a Paralleling Address of 8.
• Number of Devices (2 to 16)
• Tap Difference (2 to 8)
• Tap Position Response Timeout (1000 to 60000 ms) The Tap Position
Response Timeout is the time within which the Followers have to be at the
same tap position as that of the Master (Range 1000 to 60000 ms). If the Tap
Position Response Timeout is greater than the Intertap Delay setting, then the
Tap Position Response Timeout is used as the Intertap Delay, so that the
Master waits for all the Followers to make a tapchange before the Master takes
the next tap.
• Line Breaker "Not In Use" or "In Use" (Auxiliary Input A1)
• Line Breaker Polarity "Positive" or "Negative"
• Right Tie Breaker "Not In Use" or "In Use" (Auxiliary Input A2)
Section 6
1VAC388793-MB A
Configuration
420 TCC300
User Manual