ABB IRB 1200, Product Manual

Page: 751 / 906

Connecting the air hoses and CP/CS cabling (if equipped)
Notice that the procedure differs depending on the protection class and protection
type.
Connecting the air hoses and CP/CS cabling on robots not in protection type Hygienic
Use this procedure if the robot is not in protection type Hygienic.
Note Action
For robots with protection type Clean Room 1
For robots with food grade lubrication
Clean the joints that have been opened and wipe
the parts free from particles with spirit on a lint
free.
Air connector set with Ethernet
hole in flange: 3HAC049664-001 Reconnect the air hoses.
Replace the air hose connector set if damaged. 2
Air connector set without Ethernet
hole in flange: 3HAC049665-001
xx1400000738
xx1500000252
If equipped, reconnect the CP/CS connector.
For robots with protection class IP67
For robots with protection type Foundry Plus
1 Check the gasket.
2 Replace if damaged.
For robots with protection type Clean Room
For robots with food grade lubrication
1 Remove residual locking liquid and other
pollutants with cleaning agent Loctite 7063.
2 Apply flange sealing Loctite 574 on the
mounting surfaces of the CP/CS connector
and wipe clean if there is any overflowing
Loctite 574.
3
On robots with protection class
IP67
On robots with protection type
Foundry Plus
Gasket: 3HAC058567-001
xx1500000251
Continues on next page
Product manual - IRB 1200 751
3HAC046983-001 Revision: S
© Copyright 2014 - 2021 ABB. All rights reserved.
4 Repair
4.6.6 Replacing the axis-4 timing belt
Continued