Woodward easYgen-3000XT Series, Руководство пользователя

Страница: 542 / 1205

ID Parameter CL Setting range
[Default]
Description
87.70LM:Eng.mon Monitoring for fault conditions is
not performed until engine
monitoring is enabled. This is
determined through the
LogicsManager equation "Release
engine monitoring".
For xx = 1 to 32:96.{xx}LM:
Flag{xx} The monitoring is executed, if the
LogicsManager "Flag {xx}" is
TRUE. Example: 96.01 LM: Flag 1,
96.02 LM: Flag 2, ..., 96.32 LM:
Flag 32
4.5.4.3 Synchronization GCB
General notes
NOTICE!
If load-dependent start/stop (refer to ╚═▷ “4.4.5.5 Load Dependent Start/Stop (LDSS)” ) is
enabled, this monitoring function must be configured with a shutdown alarm class C, D,
E, or F) or disable load-dependent start/stop if triggered to ensure that the next engine
will be started.
ID Parameter CL Setting range
[Default]
Description
3060 Monitoring 2 [On] Monitoring of the GCB
synchronization is carried out
according to the following
parameters.
Off Monitoring is disabled.
3063 Delay 2 3 to 999 s
[60 s]
If it was not possible to
synchronize the GCB within the
time configured here, an alarm
will be issued.
The message "GCB syn. timeout"
is issued and the logical command
variable "08.30" will be enabled.
3061 Alarm class 2 Class A, Class B, Class C, Class D,
Class E, Class F , Control
[Class B]
Each limit may be assigned an
independent alarm class that
specifies what action should be
taken when the limit is surpassed.
Notes
For additional information refer to
╚═▷ “9.5.4 Alarm Classes”
3062 Self acknowledge 2 Yes The control unit automatically
clears the alarm if the fault
condition is no longer detected.
[No] The control unit does not
automatically reset the alarm
when the fault condition is no
longer detected.
542 easYgen-3000XT Series B37574
4 Configuration
4.5.4.3 Synchronization GCB
Released