Woodward easYgen-3000XT Series, Руководство пользователя

Страница: 212 / 1205

The possibility to arrange different sources to determine speed and firing speed comes
with more flexibility. Woodward recommends to spend some time to understand the
parameters and dependencies listed below or on ToolKit page [Parameter / Configuration /
Configure application / Configure engine / Configure start/stop].
Firing Speed detection
The “Firing Speed” detection is a basic function of the easYgen genset controls. This
information influences a lot of functions and therefore is to configure very carefully!
With the firing speed detection the device recognizes e.g. the engine as successfully
started, removes the starter immediately and triggers the timer »Monitoring delay
time« for engine speed relevant monitoring. The firing speed can be detected out of
different sources.
In comparison to the easYgen-3000 first generation, the firing speed is generated through
a LogicsManager equation always and allows all speed source combinations. By default
this LogicsManager is configured backward compatible: easYgen-XT behaves like the first
generation easYgen-3000.
Speed detection
With the “Speed” detection the device recognizes e.g. the engine as turning or as
successful stopped. The speed can be detected out of different sources.
In comparison to the easYgen-3000 first generation, the speed is generated through a
LogicsManager equation and allows all speed source combinations. By default the
LogicsManager is configured backward compatible: easYgen-XT behaves like the first
generation easYgen-3000.
The easYgen provides two LogicsManager command variables (LMCV) for detecting
speed:
• Electrical measured determined speed •
• Speed sensor (rpm) determined speed •
212 easYgen-3000XT Series B37574
4 Configuration
4.4.1.2 Engine Start/Stop
Released