IBM X3850 X6, Инструкция по установке и обслуживанию

Страница: 302 / 1730

Fan handle
5. Remove the DDR3 compute book covers. Press down on both blue touch points
and slide the cover toward the rear of the DDR3 compute book.
6. Remove the microprocessor and heat sink (see “Removing a microprocessor
and heat sink” on page 275).
7. Remove the DIMMs (see “Removing a memory module” on page 239).
8.
Remove the fans (see “Removing a hot-swap fan assembly” on page 251).
Results
If you are instructed to return the DDR3 compute book follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
Replacing a DDR3 compute book
This information provides instructions on how to replace the DDR3 compute book.
About this task
Note:
The information and installation procedures in this documentation apply to
both the 4-socket and the 8-socket configurations of the server, unless otherwise
specified. Most of the illustrations in the documentation show the 4-socket
configuration of the server.
The following are notes and information that you must consider when you install
the DDR3 compute book in the server:
v The DDR3 compute books should be installed from left to right (facing the front
of the server).
v
A minimum of two DDR3 compute books must be installed in the 4-socket
(x3850 X6) server.
v
A minimum of four DDR3 compute books must be installed in the 8-socket
(x3950 X6) server.
v
Each DDR3 compute book must have a minimum of one microprocessor and
one DIMM installed.
284
System x3850 X6 and x3950 X6 Types 3837 and 3839: Installation and Service Guide