IBM X3850 X6, Инструкция по установке и обслуживанию

Страница: 167 / 1730

11. Select the updates that you want to install, and click Install to start the
installation wizard.
Updating the Universal Unique Identifier and DMI/SMBIOS data
This topic provides information about updating the Universal Unique Identifier
and DMI/SMBIOS data on the server.
After the standard I/O book is replaced, you must update the Universal Unique
Identifier (UUID) and DMI/SMBIOS data in the integrated management module
(IMM) on the new standard I/O book board. You can use the Advanced Settings
Utility (ASU) and any of the following access methods to update the UUID and
DMI/SMBIOS data:
v
Locally (in-band)
– Through the Keyboard Controller Style (KCS) interface
– Through the LAN over USB interface
v
Remotely over a LAN
You can use the ASU under any supported operating system, or you can use the
Bootable Media Creator or a Windows- or Linux-based toolkit to create bootable
media that contains the ASU. For information about the Advanced Settings Utility
(ASU), see the
Advanced Settings Utility User's Guide and instructions for
downloading and unpacking the ASU code at http://www.ibm.com/support/
entry/portal/docdisplay?lndocid=TOOL-ASU.
For instructions for updating the UUID and DMI/SMBIOS data, using the different
methods for accessing the IMM, see “Locally: Keyboard Controller Style (KCS),”
“Locally: LAN over USB” on page 150, and “Remotely over a LAN” on page 151.
The following conventions apply to the command syntax:
v
Variables are shown in italics .
v
Optional parameters are enclosed in brackets ([ ]). Do not type the brackets in
the commands. If you omit an optional parameter, the default is used.
v
Although the command syntax is shown in mixed case, the commands are not
case sensitive.
Locally: Keyboard Controller Style (KCS)
This topic provides instructions on how to update the Universal Unique Identifier
and DMI/SMBIOS data on the server locally using the Keyboard Controller Style
(KCS) method.
Procedure
This access method uses the IPMI/KCS interface. The IPMI driver must be
installed; with some operating systems, the IPMI driver is installed by default. The
Advanced Settings Utility (ASU) provides the corresponding mapping layer.
To update the UUID, in the ASU command-line interface, enter the following
command:
asu set SYSTEM_PROD_DATA.SysInfoUUID uuid
where uuid is the user-assigned hexadecimal value, up to 16 bytes, that identifies
the server.
To update the DMI/SMBIOS data, complete the following steps:
1. In the ASU command-line interface, enter the following command:
asu set SYSTEM_PROD_DATA.SysInfoProdName xxxxyyy
Chapter 3. Configuration information and instructions
149