IBM X3850 X6, Инструкция по установке и обслуживанию

Страница: 101 / 1730

v
PCIe slots 1, 3, 4, and 6 (when two full-length I/O books are installed) are x16
Gen 3 adapter slots.
v
Double-wide adapters can only be installed in PCIe slots 1 or 4. When you
install double-wide adapters in slots 1 or 4, you cannot install an adapter in slots
2 and 5.
v
This I/O book also provides two auxiliary power connectors to support adapters
that need up to 300 watts of power.
v
For additional information about this I/O book, see full-length I/O book.
The following table lists the I/O book PCIe slot numbering and the slots associated
with each compute book (when two I/O books are installed):
Table 23. PCIe slot number and the associated compute books . Two-column tables that
shows the association between the PCIe slots and the compute books
PCIe slot number (facing the rear of the
server) Compute book associated with the PCIe
slot
1 Compute book 4
2 Compute book 4
3 Compute book 4
4 Compute book 3
5 Compute book 3
6 Compute book 3
To install the full-length I/O book, complete the following steps:
Procedure
1.
Read the safety information and installation guidelines, see “Safety” on page vii
and “Installation guidelines” on page 45.
2. Remove the filler panel from the I/O bay.
3.
Touch the static-protective package that contains the new I/O book to any
unpainted surface on the outside of the server; then, remove the I/O book from
the package.
4. Remove the I/O book cover. Slide the cover toward the front of the server and
lift it off of the I/O book.
5. Install your adapter (see “Installing an adapter in the full-length I/O book” on
page 99).
6. Install the extension bracket that comes with the I/O book. Insert the bracket
into the slots in the I/O bay (as shown in the illustration).
Chapter 2. Installing optional devices
83