IBM X3850 X6, Инструкция по установке и обслуживанию

Страница: 131 / 1730

Filler
panel
1400-watt ac
power supply
Power supply
release tab
2) Go to step 5.
b.
To install a 900-watt power supply , complete the following steps:
1) Insert the power-supply spacer into the left side (against the bay wall)
of the power-supply bay and slide it in until it snaps into place on tabs
on the side of the bay.
Filler
panel
Spacer
900-watt ac
power supply
Power supply
release tab
Spacer
release tab
2) Grasp the handle on the rear of the power supply and slide the power
supply forward into the power-supply bay (next to the spacer) until it
clicks into place. Make sure that the power supply connects firmly into
the power-supply connector.
3)
Go to step 5.
5. Route the power cord through the cable hook-and-loop on the rear of the
server so that it does not accidentally become unplugged.
6. Connect the power cord for the new power supply to the power-cord connector
on the power supply.
7. Connect the other end of the power cord to a properly grounded electrical
outlet.
8. Make sure that the ac power LED on the power supply is lit, indicating that
sufficient power is being supplied to the power supply through the power
cord. During normal operation, both the ac and the dc power LEDs are lit. For
any other combination of LEDs, see “Power-supply LEDs” on page 165. Make
sure that no error LEDs are lit.
9. Restart the server. Confirm that it starts correctly and recognizes the newly
installed device, and make sure that no error LEDs are lit.
Chapter 2. Installing optional devices
113