IBM X3850 X6, Инструкция по установке и обслуживанию

Страница: 151 / 1730

While the server is turned off, move switch 1 on the switch block SW1 to the On
position to enable the power-on password override. You can then start the Setup
utility and reset the power-on password. You do not have to return the switch to
the previous position.
The power-on password override switch does not affect the administrator
password.
Administrator password:
This topic provides information about setting an administrator password using the
server Setup utility.
If an administrator password is set, you must type the administrator password for
access to the full Setup utility menu. You can use any combination of 6 to 20
printable ASCII characters for the password.
Attention: If you set an administrator password and then forget it, there is no
way to change, override, or remove it. You must replace the standard I/O book.
Using the Boot Manager
This topic provides instructions on using the Boot Manager option in the server
Setup utility menu.
About this task
The Boot Manager is a built-in, menu-driven configuration utility program that
you can use to temporarily redefine the first startup device without changing
settings in the Setup utility.
To use the Boot Manager, complete the following steps:
Procedure
1. Turn off the server.
2. Restart the server.
3. When the prompt
<F12> Select Boot Device
is displayed, press F12.
4.
Use the Up arrow and Down arrow keys to select an item from the menu and
press Enter.
Results
The next time the server starts, it returns to the startup sequence that is set in the
Setup utility.
Chapter 3. Configuration information and instructions
133