IBM X3850 X6, Инструкция по установке и обслуживанию

Страница: 236 / 1730

Removing and replacing server components
This topic provides information about removing and replacing server components.
This section provides information for removing and replacing components in the
server.
Note: The information and procedures in this documentation for removing and
replacing components apply to both the 4-socket and the 8-socket configurations of
the server, unless otherwise specified. Most of the illustrations in the
documentation uses the 4-socket configuration of the server.
Removing and replacing consumable parts
This topic provides information about removing and replacing consumable parts.
Replacement of consumable parts is your responsibility. If IBM installs a
consumable part at your request, you will be charged for the installation.
The illustrations in this document might differ slightly from your hardware.
Removing and replacing Tier 1 CRUs
This topic provides information about removing and replacing tier 1 CRUs.
Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at
your request, you will be charged for the installation.
The illustrations in this document might differ slightly from your hardware.
Removing the DDR3 compute book cover
This information provides instructions on how to remove the DDR3 compute book
cover.
About this task
The DDR3 compute book has a cover on the left side and a cover on the right side
for access to the microprocessor and DIMMs. Use the same procedure to remove
both covers.
To access the microprocessor and DIMMs 1 through 12, remove the left cover.
To access DIMMs 13 through 24, remove the right cover.
To remove the DDR3 compute book covers, complete the following steps:
Procedure
1. Read the safety information that begins on page “Safety” on page vii and
“Installation guidelines” on page 45.
2. Turn off the server (see “Turning off the server” on page 41) and all attached
peripheral devices. Disconnect all power cords; then, disconnect all external
cables as necessary to replace the device.
3.
Remove the compute book from the server. Pull the top fan-pack handle down
and slide the blue release latch (behind the fan handle) to the right to release
the DDR3 compute book cam handle.
218
System x3850 X6 and x3950 X6 Types 3837 and 3839: Installation and Service Guide