IBM X3850 X6, Инструкция по установке и обслуживанию

Страница: 190 / 1730

Clearing the error logs
This topic provides instructions on how to clear the server error logs using Setup
utility.
About this task
To clear the event logs, complete the following steps.
Note: The POST event log is automatically cleared each time the server is
restarted.
Procedure
1. Turn on the server.
2.
When the prompt
<F1> Setup
is displayed, press F1. If you have set both a
power-on password and an administrator password, you must type the
administrator password to view the event logs.
3. Use one of the following procedures:
v
To clear the IMM system-event log, select System Event Logs --> Clear
System Event Log .
POST
This topic provides information about the power-on self-test (POST) that occurs
when you start the server.
When you turn on the server, it performs a series of tests to check the operation of
the server components and some optional devices in the server. This series of tests
is called the power-on self-test, or POST.
Note: This server does not use beep codes for server status.
If a power-on password is set, you must type the password and press Enter (when
you are prompted), for POST to run.
If POST detects a problem an error message is displayed. See Appendix C,
“UEFI/POST error codes,” on page 1665 for more information.
If POST detects a problem, an error message is sent to the POST event log, see
“Event logs” on page 168 for more information.
172
System x3850 X6 and x3950 X6 Types 3837 and 3839: Installation and Service Guide