IBM X3850 X6, Инструкция по установке и обслуживанию

Страница: 251 / 1730

v
When you mix drive backplane configurations, all 1.8-inch SSD drive backplanes
must be installed above the all 2.5-inch drive backplanes. See “Drive IDs” on
page 71 for drive ID assignment information and “Supported SAS/SATA drive
backplane configurations” on page 72 for information about the combination of
supported drive backplane configurations.
v
The electromagnetic interference (EMI) integrity and cooling of the server are
protected by having all bays and PCI Express slots covered or occupied. When
you install a drive, save the EMC shield and filler panel from the bay in the
event that you later remove the device.
v For a complete list of supported optional devices for the server, see
http://www.ibm.com/servers/eserver/serverproven/compat/us/.
To install a hot-swap drive, complete the following steps:
Procedure
1. Touch the static-protective package that contains the drive to any unpainted
metal surface on the server; then, remove the drive from the package and place
it on a static-protective surface.
2. Install a 2.5-inch hot-swap drive:
a. Make sure that the drive-tray handle is in the open (unlocked) position.
b. Align the drive assembly with the guide rails in the bay.
Drive tray
assembly
Drive handle
(in open position)
c. Gently push the drive-tray assembly into the bay until it is seat firmly in
place.
d. Rotate the drive-tray handle to the closed (locked) position.
e. Skip to step 4 on page 234.
3. Installing a 1.8-inch hot-swap drive:
a.
Insert the drive into the drive bay with the label side of the drive facing up.
Chapter 6. Removing and replacing components
233