Chevrolet 10 Series 1970, Руководство по обслуживанию

Страница: 123 / 671

BODY IB-45
F ig . 107— Ho Id -D o w n and S a fe ty Hook Assy.
NOTE: Each section o f windshield glass is r e ­
tained in place with in s e rt-ty p e rubber seal as
shown in F igu re 109.
Removal
1. P r y end of in sert out o f v e r tic a l center seal with a
pointed tool; pull in sert com p letely out of seal.
2. In sam e manner, rem o ve in sert fro m sea l around
that section of glass which is to be rem oved.
3. W ith aid of an assistant to hold glass, push glass f o r ­
w ard fro m inside cab.
Checking W indshield O pening
I f it is suspected that the windshield opening has been
d istorted through c o llis io n damage, o r i f the veh icle has
a h istory o f windshield " s t r a in b r e a k s ", the w indshield
opening should be checked as follow s:
1. R em ove windshield, rubber seal and a ll fo re ig n m a­
t e r ia l fro m w indshield fra m e.
2. P la c e a new windshield glass in opening without
rubber seal.
3. In stall checking blocks, Special T o o l J-9316, equally
spaced around p e rim e te r of opening. Blocks may be
in stalled by in sertin g them between glass and m etal
fro m outside o f cab with the two notches toward in­
side o f cab. B locks are then rotated 1/2 turn so that
wide notch engages glass and n arrow notch engages
pinchweld.
Installation
1. If n ecessary, pull rubber seal fro m glass opening,
then exam ine opening flanges fo r ir r e g u la r su rface
which could cause glass breakage. Straighten flanges
i f n ecessary.
2. Reposition rubber sea l on flange. R aise new glass
to outside of seal, then with hook end of in s ta lle r
T o o l (J-2189) in glass groove o f seal as shown in
Figu re 109 m ove tool around glass to fo r c e outer lip
of seal o v e r edge of glass.
3. Thread end of rubber in sert through handle and loop
of in s ta lle r to o l (fig . 109). P u ll tool loop and end of
in sert into g ro o ve of seal. Feed in rubber in sert,
while p roceedin g around window. U se a hitching
m ovem ent of tool to avoid elongating in sert. If new
in sert is being used, cut off in sert allow ing su fficien t
overlap to tight joint, then butt into groove.
4. In stall in s e rt in center v e r tic a l seal in sam e manner
p revio u sly d escrib ed in Step 3.
REAR VIEW MIRROR
F igu re 110 shows installation of re a r view m ir r o r on
le ft door assem bly. Note that m ir r o r head should be in­
s talled so that drain holes are at the bottom.
BODY VENTILATIO N
Outside a ir enters cab through a vent (fig . I l l ) d ire c tly
CHEVROLET TRUCK SERVICE MANUAL