AudioCodes Mediant 500 MSBR, Руководство пользователя

Страница: 1001 / 1248

Version 7.2 1001 Mediant 500 MSBR
User's Manual 74. Configuration Parameters Reference
use-zero-conf-certs
[AupdUseZeroConfCerts]
Enables the Automatic Update mechanism to use the same client-
server certificate as used for the Zero Configuration feature, instead of
the "regular" certificate used for Automatic Update.

[0] = (Default) The device uses the "regular" certificate for Automatic
Update.

[1] = The device uses the Zero Configuration certificate for the
Automatic Update feature.
tftp-block-size
[AUPDTftpBlockSize]
Defines the size of the TFTP data blocks (packets) when downloading a
file from a TFTP server for the Automatic Update mechanism. This is in
accordance to RFC 2348. TFTP block size is the physical packet size
(in bytes) that a network can transmit. When configured to a value
higher than the default (512 bytes), but lower than the client network’s
Maximum Transmission Unit (MTU), the file download speed can be
significantly increased.
The valid value is 512 to 8192. The default is 512.
Note:

A higher value does not necessarily mean better performance.

The block size should be small enough to avoid IP fragmentation in
the client network (i.e., below MTU).

This feature is applicable only to TFTP servers that support this
option.
[ResetNow] Invokes an immediate device reset. This option can be used to activate
offline (i.e., not on-the-fly) parameters that are loaded using the
parameter IniFileUrl.

[0] = (Default) The immediate restart mechanism is disabled.

[1] = The device immediately resets after an ini file with the
parameter set to 1 is loaded.
Note: If you use the parameter in an ini file for periodic automatic
provisioning with non-HTTP (e.g., TFTP) and without CRC, the device
resets upon every file download.
Software/Configuration File URL Path for Automatic Update Parameters
CLI path: configure system > automatic-update
firmware
[CmpFileURL]
Defines the name of the cmp file and the URL address (IP address or
FQDN) of the server on which the file is located.
For example: http://192.168.0.1/filename
Note:

For the parameter to take effect, a device reset is required.

When the parameter is configured, the device always loads the cmp
file after it is reset.

The cmp file is validated before it's burned to flash. The checksum of
the cmp file is also compared to the previously burnt checksum to
avoid unnecessary resets.

The maximum length of the URL address is 255 characters.
voice-configuration
[IniFileURL]
Defines the name of the ini file and the URL address (IP address or
FQDN) of the server on which the file is located.
For example:
http://192.168.0.1/filename
http://192.8.77.13/config_<MAC>.ini
https://<username>:<password>@<IP address>/<file name>