AudioCodes Mediant 500 MSBR, Руководство пользователя

Страница: 442 / 1248

User's Manual 442 Document #: LTRT-10375
Mediant 500 MSBR
Tel Profile Parameter Global Parameter

For more information on fax transport methods, see
Fax/Modem Transport Modes on page 166.

The corresponding global parameter is IsFaxUsed.
Enable Digit Delivery
digit-delivery
[TelProfile_EnableDigitDelivery]
Enables the Digit Delivery feature, which sends DTMF digits
of the called number to the device's port (analog)/B-channel
(digital) (phone line) after the call is answered (i.e., line is off-
hooked for FXS, or seized for FXO) for IP-to-Tel calls.

[0] Disable (default)

[1] Enable
Digital interfaces: If the called number in IP-to-Tel call
includes the characters 'w' or 'p', the device places a call
with the first part of the called number (before 'w' or 'p') and
plays DTMF digits after the call is answered. If the character
'w' is used, the device waits for detection of a dial tone
before it starts playing DTMF digits. For example, if the
called number is '1007766p100', the device places a call
with 1007766 as the destination number, then after the call is
answered it waits 1.5 seconds ('p') and plays the rest of the
number (100) as DTMF digits.
Additional examples: 1664wpp102, 66644ppp503, and
7774w100pp200.
Note:

For the parameter to take effect, a device reset is
required.

Analog interfaces: The called number can include
characters 'p' (1.5 seconds pause) and 'd' (detection of
dial tone). If character 'd' is used, it must be the first 'digit'
in the called number. The character 'p' can be used
several times.
For example (for FXS/FXO interfaces), the called number
can be as follows: d1005, dpp699, p9p300. To add the 'd'
and 'p' digits, use the usual number manipulation rules.

Analog interfaces: To use this feature with FXO
interfaces, configure the device to operate in one-stage
dialing mode.

Analog interfaces: If the parameter is enabled, it is
possible to configure the FXS/FXO interface to wait for
dial tone per destination phone number (before or during
dialing of destination phone number). Therefore, the
parameter IsWaitForDialTone (configurable for the entire
device) is ignored.

Analog interfaces: The FXS interface send SIP 200 OK
responses only after the DTMF dialing is complete.

The corresponding global parameter is
EnableDigitDelivery.
Dial Plan Index
dial-plan-index
[TelProfile_DialPlanIndex]
DialPlanIndex
Digital Cut Through
digital-cut-through
[TelProfile_DigitalCutThrough]
Enables PSTN CAS channels/endpoints to receive incoming
IP calls even if the B-channels are in off-hook state.

[0] Disable (default)