AudioCodes Mediant 500 MSBR, Руководство пользователя

Страница: 1177 / 1248

Version 7.2 1177 Mediant 500 MSBR
User's Manual 74. Configuration Parameters Reference
Analog TTX Voltage
Level
[AnalogTTXVoltageLev
el ]
Determines the metering signal/pulse voltage level (TTX).

[0] 0V = 0 Vrms sinusoidal bursts.

[1] 0.5V = (Default) 0.5 Vrms sinusoidal bursts.

[2] 1V = 1 Vrms sinusoidal bursts
Note:

For the parameter to take effect, a device reset is required.

The parameter is applicable only to FXS interfaces.
Charge Codes Table
Charge Codes
configure voip >
gateway analog charge-
code
[ChargeCode]
Defines metering tones and their time intervals.
The format of the ini file table parameter is as follows:
[ChargeCode]
FORMAT ChargeCode_Index = ChargeCode_EndTime1,
ChargeCode_PulseInterval1, ChargeCode_PulsesOnAnswer1,
ChargeCode_EndTime2, ChargeCode_PulseInterval2,
ChargeCode_PulsesOnAnswer2, ChargeCode_EndTime3,
ChargeCode_PulseInterval3, ChargeCode_PulsesOnAnswer3,
ChargeCode_EndTime4, ChargeCode_PulseInterval4,
ChargeCode_PulsesOnAnswer4;
[\ChargeCode]
Note:

To associate a configured Charge Code to an outgoing Tel-to-IP call,
use the Tel-to-IP Routing table.

To configure the Charge Codes table using the Web interface, see
Configuring Charge Codes Table on page 593.
74.10.9 Telephone Keypad Sequence Parameters
The telephony keypad sequence parameters are described in the table below.
Table 74-65: Telephone Keypad Sequence Parameters
Parameter Description
Call Pickup Key
configure voip > sip-
definition settings >
call-pickup-key
[KeyCallPickup]
Defines the keying sequence for performing a call pick-up. Call pick-up
allows the FXS endpoint to answer another telephone's incoming call by
pressing this user-defined sequence of digits. When the user dials these
digits (e.g., #77), the incoming call from another phone is forwarded to the
user's phone.
The valid value is a string of up to 15 characters (0-9, #, and *). By
default, no value is defined.
Note:

Call pick-up is configured only for FXS endpoints pertaining to the
same Trunk Group.

The parameter is applicable only to FXS interfaces.
Prefix for External Line
[Prefix2ExtLine] Defines a string prefix (e.g., '9' dialed for an external line) that when
dialed, the device plays a secondary dial tone (i.e., stutter tone) to the
FXS line and then starts collecting the subsequently dialed digits from the
FXS line.
The valid range is a one-character string. By default, no value is defined.