AudioCodes Mediant 500 MSBR, Руководство пользователя

Страница: 1131 / 1248

Version 7.2 1131 Mediant 500 MSBR
User's Manual 74. Configuration Parameters Reference
DID Wink
configure voip > sip-
definition settings > did-
wink-enbl
[EnableDIDWink]
Global parameter enabling Direct Inward Dialing (DID) using Wink-Start
signaling, typically used for signaling between an E-911 switch and the
PSAP.
You can also configure the feature per specific calls, using Tel Profiles
(TelProfile_EnableDIDWink). For a detailed description of the parameter
and for configuring the feature in the Tel Profiles table, see Configuring
Tel Profiles on page 440.
Note:

The parameter is applicable to FXS and FXO interfaces.

If the feature is configured for a specific Tel Profile, the settings of the
global parameter is ignored for calls associated with the Tel Profile.
configure voip > sip-
definition settings >
time-between-did-winks
[TimeBetweenDIDWink
s]
Defines the interval (in msec) for wink signaling:

Double-wink signaling [2]: interval between the first and second wink

Wink and Polarity signaling [3]: interval between wink and polarity
change
The valid range is 100 to 2000. The default is 1000.
Note: See the EnableDIDWink parameter for configuring the wink
signaling type.
Delay Before DID Wink
configure voip > sip-
definition settings >
delay-b4-did-wink
[DelayBeforeDIDWink]
Defines the time interval (in msec) between the detection of the off-hook
and the generation of the DID Wink.
The valid range is 0 to 1,000. The default is 0.
Note: The parameter is applicable only to FXS interfaces.
NTT-DID-signaling-form
[NTTDIDSignallingForm
]
Determines the type of DID signaling support for NTT (Japan) modem:
DTMF- or Frequency Shift Keying (FSK)-based signaling. The devices
can be connected to Japan's NTT PBX using 'Modem' DID lines. These
DID lines are used to deliver a called number to the PBX.

[0] = (Default) FSK-based signaling

[1] = DTMF-based signaling
Note: The parameter is applicable only to FXS interfaces.
configure voip > sip-
definition settings >
enable-did
[EnableDID]
This table parameter enables support for Japan NTT 'Modem' DID. FXS
interfaces can be connected to Japan's NTT PBX using 'Modem' DID
lines. These DID lines are used to deliver a called number to the PBX.
The DID signal can be sent alone or combined with an NTT Caller ID
signal.
The format of the ini file table parameter is as follows:
[EnableDID]
FORMAT EnableDID_
Index = EnableDID_ IsEnable ; EnableDID_Port,
EnableDID_Module;
[\EnableDID]
Where,

IsEnable = Enables [1] or disables [0] (default) Japan NTT Modem DID
support.

Port = Port number.

Module = Module number.
For example:
EnableDID 0 = 1,1,2; (DID is enabled on Port 1 of Module 2)
Note: The parameter is applicable only to FXS interfaces.