AudioCodes Mediant 500 MSBR, Руководство пользователя

Страница: 736 / 1248

User's Manual 736 Document #: LTRT-10375
Mediant 500 MSBR
41.5.2 Configuring BroadSoft's Shared Phone Line Call Appearance for
Survivability
The device can provide redundancy for BroadSoft's Shared Call Appearance feature.
When the BroadSoft application server switch (AS) fails or does not respond, or when the
network connection between the device and the BroadSoft AS is down, the device
manages the Shared Call Appearance feature for the SIP clients.
The feature is supported by configuring a primary extension and associating it with
secondary extensions (i.e.,
shared lines ) so that incoming calls to the primary extension
also ring at the secondary extensions. The call is established with the first extension to
answer the call and consequently, the ringing at the other extensions stop. For example,
assume primary extension number 600 is shared with secondary extensions 601 and 602.
In the case of an incoming call to 600, all three phone extensions ring simultaneously,
using the device's call forking feature as described in Configuring SIP Forking Initiated by
SIP Proxy on page 734. Note that incoming calls specific to extensions 601 or 602 ring only
at these specific extensions.
Figure 41-6: Call Survivability for BroadSoft's Shared Line Appearance
To configure this capability, you need to configure a shared-line, inbound manipulation rule
for registration requests to change the destination number of the secondary extension
numbers (e.g. 601 and 602) to the primary extension (e.g., 600). Call forking must also be
enabled. The following procedure describes the main configuration required.
Note:
•
The device enables outgoing calls from all equipment that share the same line
simultaneously (usually only one simultaneous call is allowed per a specific
shared line).
•
You can configure whether REGISTER messages from secondary lines are
terminated on the device or forwarded transparently (as is), using the
SBCSharedLineRegMode parameter.
•
The LED indicator of a shared line may display the wrong current state.

To configure BroadSoft's Shared Line feature:
1. In the IP Groups table (see Configuring IP Groups on page 333), add a Server-type IP
Group for the BroadWorks server.
2. In the IP Groups table, add a User-type IP Group for the IP phone users and set the
'SBC Client Forking Mode' parameter to
Parallel so that the device forks incoming
calls to all contacts under the same AOR registered in the device's registration
database.
3. In the IP-to-IP Routing table (see Configuring SBC IP-to-IP Routing Rules on page
671), add a rule for routing calls between the above configured IP Groups.